Masonry connectors/flat tie rod Stainless steel, material no. 1.4401, 1.4571, 1.4362 in line with DIN 17440
Wall connector/flat tie rod, A4 stainless steel
MNCON-V4A-300X15X0,5
Art.-no.
0993681130
EAN 4052712108563
Prices for customers after login
Show availability in Würth trade store
In order to check the stock in a Würth branch, please log in.
If you have any questions, please call our service hotline at 073 – 629 1911.
You are not yet a Würth customer or do not yet have access data to the Online Shop? Then register now in just a few steps. After a successful check of the entered data, you will have immediate access to the stock inquiry as well as all prices and can immediately order.
Exclusively for trade customers
Register now and access more than 125,000 products
For connecting masonry walls using the butt joint method
Notice
Only approved for horizontal installation.
It is essential to observe the information on calculation and processing found in the approval.
Technical approval Z-17.1-711
Product information
Datasheets(X)
Instructions
- Masonry connectors must be embedded completely in the joint. To ensure this, insert the connector halfway up the joint and cover the top with mortar
- Minimum joint thickness 2 mm (for masonry constructed using the thin bed method)
- Install perpendicular between the end faces of the walls being connected
- Butt joints between walls running at different angles must always have mortar applied across the entire thickness of the wall
- Minimum bond length: 140 mm
Material | Stainless steel |
Surface | Anodised |
Length | 300 mm |
Width | 15 mm |
Thickness | 0.5 mm |
Type description | MV-III |
Colour | Stainless steel coloured, Chrome coloured |